BASEstartm Classic DAS for Siemens H1tm Protocol

BASEstartm Classic DAS
for Siemens H1tm Protocol

Installation and User's Guide

Order Number: AA-R219B-TE


April 2000

This manual describes how to install and use the DAS for Siemens H1 Protocol for BASEstar Classic on OpenVMS.

Revision/Update Information: This is a revised document.

Operating System and Version: OpenVMS/Alpha Version 6.1

Operating System and Version: OpenVMS/VAX Version 5.5-2

Interface Software and Version: BASEstar Classic Version 3.4

Software Version: BASEstar Classic DAS for Siemens H1 Protocol, Version 3.4A

Compaq Computer Corporation
Houston, Texas


April 2000

© 1991 Compaq Computer Corporation

Compaq, VMS and VAX Registered in U.S. Patent and Trademark Office.

BASEstar and OpenVMS are trademarks of Compaq Information Technologies Group, L.P. in the United States and/or other countries.

H1, Simatic, and SINEC are trademarks of Siemens AG.

All other products mentioned herein may be trademarks or registered trademarks of their respective companies.

Confidential computer software. Valid license from Compaq or authorized sublicensor required for possession, use or copying. Consistent with FAR 12.211 and 12.212, Commercial Computer Software, Computer Software Documentation and Technical data for Commercial Items are licensed to the U.S. Government under vendor's standard commercial license.

Compaq shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is subject to change without notice.

This document is available on :CD-ROM.

This document was prepared using DECdocument, Version V3.3b.

Contents Index


Preface

This document describes how to install and use the BASEstar Classic DAS for Siemens H1 Protocol.

Intended Audience

This document is intended for use by system managers who must set up and maintain the following:

This document is also intended for use by application programmers who develop plant-floor management software layered on BASEstar Classic software.

Readers of this document should have a solid understanding of OpenVMS operations and administration, as well as OpenVMS application software. In addition, knowledge of Seimens Siemens programmable controllers and the specific requirements of the installation site is essential.

Document Structure

This document is organized as follows:

Associated Documents

Further information on topics covered in this document can be found in the following documents:

Information on DECnet Plus installation, configuration and programming can be found in the following documents.

Refer also the documentation produced by Siemens for the SH1 Type S115U, SH1 Type S135U, SH1 Type S150U and SH1 Type S150U programmable controllers.

Conventions

This manual uses the following conventions:
Boldface Highlights user input within textual descriptions.
[Return] Press the key labeled Return. Unless otherwise specified, press [Return] after entering a command or responding to a prompt.
Enter Type the words or symbols described and press [Return].


Next Contents Index